15
Bevel Adjustment
A.
Disconnect battery pack from tool.
B.
Loosen the bevel adjustment lever
5
and
the rear bevel adjustment knob
15
.
C.
Align to desired angle on the bevel scale
7
. The foot can be adjusted up to 50°.
D.
Tighten bevel adjustment knob
15
and
lever
5
(Fig. 5).
Because of the increased amount of blade
engagement in the work and decreased
stability of the foot, blade binding may
occur. Keep the saw steady and the foot
firmly on the workpiece.
Cutting Line Guide Notches
The marked notches
8
and
9
at the front of
the footplate indicate the approximate line
of the cut (Fig. 7).
When track is not being used:
•
For a non-bevelled cut, use 0° notch
8
.
•
For 45° and 50° bevel cuts, use 45°
notch
9
.
When track is being used:
•
For both beveled and non-beveled cuts
use 0° notch
8
.
For all cuts:
•
To ensure minimum splintering on the
good side of the material to be cut, face
the good side down.
•
Make sample cuts in scrap lumber to
verify actual line of cut. This will be
helpful because of the variety of blade
types and thicknesses that are available.
•
Use RIGHT side of notch when the part
of the workpiece that is to the left of the
blade is the scrap piece (Fig. 7a).
•
Use LEFT side of notch when the part of
the workpiece that is to the right of the
blade is the scrap piece (Fig. 7b).
User Interface (Fig. 8)
The user interface
3
is used to select the
preset speed levels and to indicate the
status of the power tool and battery.
ECO MODE
When full power is not needed, the saw’s
energy-saving ECO mode can be used to
reduce the saw’s output power in order to
extend the runtime.
I f t h e E C O m o d e i s a c t i v e , t h e s p e e d
l e v e l / m o d e i n d i c a t o r
3 d
d i s p l a y s t h e
symbol “E” and “ECO” icon
3b
lights up.
SPEED PRESETS
The speed settings and the ECO mode are
preprogrammed and can be adjusted via
t h e ‘ B o s c h T o o l b o x ’ a p p . F o r m o r e
i n f o r m a t i o n o n t h e ‘ B o s c h T o o l b o x ’
application, refer to the “Connectivity”
chapter on the next page. The table below
d e s c r i b e s t h e p r e s e t s p e e d s a n d E C O
mode speed.
BATTERY CHARGE INDICATOR
When the battery charge indicator
3a
is
glowing
green
, the battery is charged and
the number of bars shows the level of the
Operating Instructions
0°
45°
0°
45°
8
9
Fig. 7
Fig. 7a
Fig. 7b
3b
3
3a
3c
3d
3e
3f
3g
Preset Speeds
Eco
3630/min
1
2500/min
2
3000/min
3
3500/min
4
4000/min
5
4500/min
6
5000/min
Fig. 8
1600A01UV3.qxp_GKS18-25 4/27/20 8:12 AM Page 15
