Depth Adjustment
Adjust the cutting depth
s o t h a t n o m o r e t h a n
one tooth is visible below the work piece.
E x c e s s i v e b l a d e e x p o s u r e b e l o w t h e
workpiece could result in personal injury
and/or property damage.
The depth adjustment
system should be not
used to change the depth while the saw is
in operation, or for plunge cutting.
If
blade adjustment shifts while cutting, it
may cause binding and kickback.
To adjust the cutting depth follow these
instructions (Fig. 4):
A.
Disconnect battery pack
17
from tool.
B.
Loosen the depth adjustment lever
6
located on the left side of the tool.
C.
Hold the foot
13
down with one hand
and raise or lower saw by the handle
3
.
-
For a smaller cutting depth, pull the
saw away from the foot
13
;
-
for a deeper cutting depth, push the
saw toward the foot
13
. The cutting
depth scale
15
has both inch and
metric scales.
D.
Tighten the depth adjustment lever at
the desired depth setting.
Note:
Not more than one tooth length of
the blade should extend below the material
to be cut, for minimum splintering (Fig. 5).
90° Cutting Angle Check
A.
Disconnect battery pack
17
from tool.
B.
Set foot to maximum depth of cut
setting.
C.
Loosen adjustment lever
5
, set to 0° on
bevel scale
7
, retighten lever
5
(Fig. 5).
D.
Check for 90° angle between the blade
and bottom plane of foot
13
with a
square (Fig. 6). If necessary, make
adjustments by turning the small
alignment screw
27
from bottom side of
foot
13
with a 2.5 mm allen wrench [not
included] (Fig. 6).
14
Operating Instructions
5
7
One tooth length should
penetrate wood for minimum
splintering
Fig. 5
13
27
20
17
90°
Fig. 6
15
6
17
13
3
Fig. 4
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories.
Such preventive safety measures
reduce the risk of starting the tool accidentally.
1600A0235F.qxp_GKS18-25C 4/20/20 8:17 AM Page 14