12
B
A
C
D
E
FIG. 9
6.
Lower the motor until the target
scale value is reached.
7.
Turn the clamping knob to the
middle position
symbol, for fine
adjustment (
C
, Fig. 9). Always
make sure the motor is held tightly
in the base.
8.
Check the depth-of-cut and make
fine adjustment if necessary (
D
,
Fig.
9).
See
FINE
DEPTH
ADJUSTMENT section below for
details.
9.
Turn the clamping knob to the
bottom, locked position
(
E
, Fig.
9). Always make sure the motor
sits tightly in the base.
Note:
the depth of the motor and bit
m a y s h i f t v e r y s l i g h t l y w h e n t h e
clamping knob is turned to the locked
position.
10. Make a trial cut to verify that the
router is set to make the cut as
desired.
▼ FINE DEPTH ADjUSTMENT
Adjust the depth-of-cut only when the
motor is switched off.
1.
Turn the clamping to the middle
position
symbol, for fine
adjustment (
C
, Fig. 9).
2.
Adjust the desired depth-of-cut
with the knurled wheel on back of
base (
D
, Fig. 9). Rotate the knurled
wheel clockwise to increase the
KNURLED WHEEL
DEPTH SCALE
CLAMPING KNOB
MOTOR
BASE
Operating Instructions
2610052572_GKF125CE 9/18/18 12:11 PM Page 12
