Bosch FPA-1200, Информация о системе

Страница: 123 / 174

Modular fire panel Installation | en 123
Bosch Sicherheitssysteme GmbH System Information 07.2020 | 12.0 | F.01U.028.089
FSH 0000 A
THP 2020 A
FRS 0019 A
THP 2020 A
Figure 4.76: THP 2020 A mounting frame/installation kit
General Information
– The following information can be sent to the printer:
–
Operating procedures on the panel (e.g. daytime operation)
– Alarm and fault messages
– Plain text; programming is carried out via the programming software FSP-5000-RPS.
– On every printout:
–
The current date and the time are specified.
– The most recent event is always at the top
– Entries stored in the history log can also be printed if the operator has the appropriate
operational authorization.
– Always ensure the printer cover panel is closed properly. If the device contact is opened,
incoming messages cannot be printed, even at a later date, as the printer does not have
its own message memory. In this case, the message only appears on the display of the
control panel.
– If the supply of paper is nearing its end, this is indicated by a message on the display of
the control panel. When this message appears, you still have enough paper on the roll to
print approx. 200 lines of text.
Printer Settings using Jumpers
Notes:
–
The jumpers BR2, BR3 and BR4 must not be inserted if connecting to the fire panel.
– Caution: Inserting jumper BR1 changes the character set from Western to Cyrillic.