6 720 803 029 (2011/08)
Modules for control units CSM 7x0, CFB 8x0 and CFB 9x0
Safety
|
7
Observe the following safety instructions during the installation of the
function modules.
2.6
Disposal
z
Electronic components must not be disposed of with general domestic
waste.
Dispose of old modules correctly through an authorised disposal site.
WARNING!
RISK TO LIFE
from electricity.
z
Ensure that all electrical work is only carried out by an authorised
electrician.
z
Before opening the control unit: Isolate all poles of the power
supply and secure against unintentional reconnection.
WARNING!
RISK TO LIFE
from electricity.
The risk of voltage flashes through unintentional loosening of the cores
at the terminals between the 230 V and the LV
1)
must be prevented.
z
Therefore fix the wires from each cable away from each other
(e.g. with cable ties) or only strip the wire for a very short section.
1)
LV-terminal - extra low voltage connection for sensors, volt free connections and BUS.
CAUTION!
DAMAGE TO THE APPLIANCE
through electrostatic discharge (ESD).
z
Before unpacking the modules touch a radiator or a earthed metal
water pipe to discharge any electrostatic charge in your body.
USER INFORMATION
Ensure that a regulation isolator is available to disconnect all poles
from the mains power supply. Install an isolator if none is available.
USER INFORMATION
Only use original replacement parts from Bosch Thermotechnology.
Bosch Thermotechnology cannot take responsibility for losses caused
by the use of parts not supplied by Bosch Thermotechniology.
