Bosch FlexiDome XT+, Руководство по установке

Страница: 11 / 210

FlexiDome
XT+
| Installation Manual
Bosch Security Systems | 2008-08 | V1.1
EN | 11
Figure 4 Surface mounting - rear connection
Surface mounting
When using the raised mounting box:
•
With a side connection, remove the cap covering the side entrance.
With a rear connection, leave the cap in place.
• Attach the conduit to the mounting box.
• Release the two clips at the bottom of the watertight connection
compartment to remove it from the mounting box.
• Open the cover of the watertight compartment in the mounting box by
releasing the 5 clips.
• Run the power and video wires through separate rubber grommets into
the watertight compartment.
• Run the cable from the camera into the watertight compartment
through the supplied grommet.
• Make the connection inside the watertight compartment and clip on
the cover to seal it.
Note
In order to ensure a watertight cable entry, use round cables of between 5
and 6 mm (0.2 - 0.24 inches) for power and video connection. Use some
silicon spray on the cable to help slide the grommets onto it.
Cap
Three screws
(M5, supplied)
Surface
mounting box
(VDA-455SMB)
Conduit
Three screws
(supplied with
camera)
Camera unit
and base
Solid surface
(three pre-drilled
8mm holes)
Wires