en
Operating the appliance
8
Saturation display
If the metal grease filters or the activated charcoal filter
are/is saturated, the corresponding symbols flashes
after the appliance is switched off:
■
Metal grease filters:
#
and 1
■
Activated charcoal filter:
#
and 2
■
Metal grease filter and activated charcoal filter:
#
,
1 and 2
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced.
~
"Cleaning and maintenance" on page 10
Note:
The saturation indicator does not apply for non-
renewable activated charcoal filters that are inserted
downstream of the metal grease filter. These activated
charcoal filters must be replaced twice a year.
The saturation indicators can be reset while they are
flashing. To do this, touch the
#
symbol.
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■
The extractor hood must be connected and switched
off.
■
Touch and hold the
D
symbol. Touch the "2"
symbol.Take your finger off the
D
symbol. This
will switch the electronic controller over to air
recirculation mode (filters that cannot be
regenerated).
■
Touch and hold the
D
symbol. Touch the "3"
symbol.Take your finger off the
D
symbol. This
will switch the electronic controller over to air
recirculation mode (filters that can be regenerated).
■
Repeatedly touching and holding the
D
symbol
and touching the "1" symbol switches the electronic
controller back over to air extraction mode.
Audible signal
Switching on
Touch and hold the
#
and
y
symbols at the same
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
Switching off
Touch and hold the
#
and
y
symbols at the same
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
Содержание DWB98JQ50B
Страница 2: ......
