Operating the appliance
en
7
Control panel model 3
Control panel
Setting the fan
Switching on the appliance
■
Press the
%
button.
The fan starts at setting
ƒ
.
■
Press the + or - button to change the fan strength.
Switching off
■
Press the
%
button.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting
„
.
The intensive boost setting
‚
is activated. Pressing the +
button again activates the intensive boost
ƒ
setting.
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Automatic mode
Switching on the appliance
■
Press the
%
button.
The fan starts at
ƒ
setting.
■
Press the
1
button.
The optimum fan setting
‚
,
ƒ
or
„
is automatically
set via a sensor.
Switching off the appliance
Press the
1
or
%
button to switch off automatic mode.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
The automatic mode lasts 4 hours at most.
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting fumes.
Depending on the setting of the sensor, the fan
automatically switches to another fan setting.
Default sensitivity setting:
†
Lowest sensitivity setting:
‹
Highest sensitivity setting:
Š
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1.
When the fan is switched off, press the
1
button and
hold it for approx. 4 seconds. The setting is
displayed.
2.
Press the + or - button to change the setting of the
sensor control.
3.
To confirm the entries, press and hold the
1
button
for approx. 4 seconds.
Fan run-on time
The fan run-on time is possible at every fan setting
(except boost
‚
and boost
ƒ
).
Select the desired fan setting and press the
r
button.
Š
min
r
appears on the display.
Once this time has elapsed, the fan switches off
automatically.
Setting the run-on time
When
Š
min
r
appears on the display, press the + or -
button.
You can set a run-on time of between 1 and 9 minutes.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
B
button.
Setting the brightness
Press and hold the
B
button until the desired
brightness is reached.
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off.
In addition, the corresponding symbol appears in the
display:
■
Metal mesh grease filter:
#
■
Activated carbon filter:
’
#
If you have not yet done so, the metal mesh grease
filters should be cleaned or the activated carbon filter
changed now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section
Cleaning and
maintenance
.
While the saturation displays are flashing, they can be
reset. To do this, press the – button.
Explanation
%
Fan on/off
1
Eco function (automatic mode)
-
Reduce the fan settings
+
Increase the fan settings/intensive setting 1, 2
r
Fan run-on time
B
Light on/off/dimming
HFR
ERRVW
HFR