Bosch DWA06E621, Инструкция по эксплуатации

Страница: 8 / 20

8
Removing metal grease filter
1.
Open the lock on the underside of the appliance and remove
the metal grease filters from the retainer.
Note:
Grease may accumulate in the bottom of the metal
grease filter. Hold the metal grease filter level, otherwise
grease will drip out.
2.
Clean the metal grease filter.
3.
After removing the filters, clean the inside of the appliance.
4.
Clean the filter cover.
Installing the metal mesh grease filter
1.
Insert the metal grease filters with the lock to the front.
Insert the metal grease filters on the underside of the
appliance.
2.
Fold the metal grease filters inwards, locking them in place.
3.
Press and hold the
#
button for more than three seconds.
The saturation indicator is reset.
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
■
The activated charcoal filters are not included in the delivery.
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
■
The activated charcoal filters cannot be cleaned or
reactivated.
Removing the activated charcoal filter
1.
To remove the metal grease filter, see above.
2.
Undo the screw connections on the retainer.
¨
3.
Fold the retainer down and remove it.
©
Fitting the activated charcoal filter
1.
Slide the new activated charcoal filter into the retainer.
2.
Slide the wire into the retainer.
3.
Insert the retainer into the extractor hood.
4.
Close the screw connections on the retainer.
5.
To fit the metal grease filter, see above.
6.
Press and hold the # button until the saturation indicator no
longer flashes.
The saturation indicator is reset.
Trouble shooting
Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Malfunction table
--------
$ %
Problem Possible cause Solution
The appliance
does not work
The plug is not
plugged in.
Connect the appliance to
the electricity supply
Power cut Check whether other
kitchen appliances are
working
Faulty fuse Check in the fuse box to
make sure that the fuse for
the appliance is OK
The button illu-
mination does
not work.
The control unit
is faulty.
Call the after ­ sales service.
The lighting
does not work.
The bulbs are
faulty.
For information on chang-
ing the bulbs, see the
"Replacing Bulbs" section.
‚
or
ƒ
flashes
in the display
The grease or
activated char-
coal filter is sat-
urated.
Clean the filter – see the
section "Cleaning and main-
tenance".
‚
or
ƒ
flashes
in the display
The grease and
activated char-
coal filters are
saturated.
Clean the filter – see the
section "Cleaning and main-
tenance".
£ flashes in the
display
The ambient
temperature of
the display
panel is above
the tempera-
ture alarm limit.
Switch off the temperature
alarm – see the section
"Temperature alarm limit".