Bosch DMExPCHxx, Инструкция по эксплуатации

Страница: 7 / 16

1 UNPACKING
Unpack carefully. This is electromechanical equipment and should be handled with care.
Check to be sure that all of the following parts are included:
• Dome housing with camera and lens.
• Dome top cover (pendant versions only).
If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any
items are missing, notify your Bosch Security Systems Sales Representative or Customer Service Representative.
The shipping carton is the safest container in which the unit may be transported. Save it for possible future use.
2 MODEL NUMBERS
Model No. 1 Description Voltage Power
DMExRMSxx Indoor, In-ceiling, 1/4-inch, B/W, 380 TVL 24 VAC 3 W
DMExRMHxx Indoor, In-ceiling, 1/4-inch, B/W, 570 TVL 24 VAC 3 W
DMExRCSxx Indoor, In-ceiling, 1/4-inch, Color, 330 TVL 24 VAC 3 W
DMExRCHxx Indoor, In-ceiling, 1/4-inch, Color, 480 TVL 24 VAC 3 W
DMExPMSxx Indoor, Pendant, 1/4-inch, B/W, 380 TVL 24 VAC 3 W
DMExPMHxx Indoor, Pendant, 1/4-inch, B/W, 570 TVL 24 VAC 3 W
DMExPCSxx Indoor, Pendant, 1/4-inch, Color, 330 TVL 24 VAC 3 W
DMExPCHxx Indoor, Pendant, 1/4-inch, Color, 480 TVL 24 VAC 3 W
1. NOTE: a W at the end of a number indicates a Wall-mounted version (e.g. DME6PMS38W).
3 SERVICE
If the unit ever needs repair service, the customer should contact the nearest Bosch Security Systems Service Center for
return authorization and shipping instructions.
Service Centers
U.S.A.: phone: 800-366-2283, or 717-735-6638
fax: 800-366-1329, or 717-735-6639
email: BoschCCTVparts@ca.slr.com
Canada: 514-738-2434
Europe & Middle East & Asia Pacific Region: 32-1-440-0711
For additional information, see www.boschsecurity.com
4 INSTALLATION
ATTENTION
: Installation should be performed by qualified service personnel only, in accordance
with the National Electrical Code or applicable local codes. Refer to applicable installation section.
4.1 In-ceiling Model (DMExRx Series)
CAUTION
: These units must be properly and securely mounted to a supporting structure capable of
sustaining the unit weight. Use care when selecting mounting hardware (not supplied) for installation,
the mounting surface and unit’s weight should be carefully considered.
1. Use 2 pencils or a pencil and nail with provided template to cut a 146 mm (5.75-inch) diameter
hole in the ceiling where required. The template is found at the top of the shipping carton, attached to the package
insert. Connect low voltage power and video (see
Figure 1 ).
NOTE:
Power and video can be connected before or after the unit is mounted into the ceiling:
a. Connect the line and neutral wires to the terminal block in the back of the housing.
b. Route and connect video cable to the BNC connector also located on the back of the housing.
6