Bosch DIP-2040EZ-00N, Руководство по установке

Страница: 27 / 40

See also:
–
Chassis setup, page 16
Extending an empty unit
You can extend an empty unit with 2 or 4 additional hard disks.
To add hard disks to an empty unit:
1.
Insert the new hard disks into the chassis bay, making sure
that the drive carrier handle is completely closed.
2. Turn on the unit by pressing the power button.
3. The unit identifies the hard disks as new and starts the
recovery menu automatically.
After finishing the recovery process the DIVAR IP software
is installed. The individual disk status LED to the right of
the disk carrier will turn blue.
4. Perform a basic configuration using the configuration
wizard.
See also:
–
Chassis setup, page 16
– Obtainging a basic configuration, page 20
Replacing hard disks
If a hard disk fails, the individual disk status LED to the right of
the disk carrier will turn red.
To replace hard disks:
1.
Remove the defective hard disk. Use the handle to pull the
disk carrier out of the chassis.
Note: You can remove the hard disk during operation.
2. Turn off the unit by pressing the power button.
3. Insert the new hard disks into the chassis bay, making sure
that the drive carrier handle is completely closed.
4. Turn on the unit by pressing the power button.
5. Open DIVAR IP Dashboard with any browser. To do this, in
the address bar of the web browser, enter
http://
mydivar/dlacockpit
or
http://<IP address of DIVAR
8.4.2
8.4.3
DIVAR IP 2000 Maintaining the system | en 27
Bosch Sicherheitssysteme GmbH 2014.07 | V1 | DOC