en
Installation instructions
32
2.
Place the flue duct extension in-
side the flue duct.
Gently push downward till touches
the chimney body.
3.
Fix the bottom angle bracket to the
wall as shown in above figure.
4.
Fix the top angle brocket as per
the required height of flue duct ex-
tension ap shown in above figure.
The minimum overlap between flue
duct and flue duct extension must
be 100 mm.
5.
Screw the flue duct extension to
the ends of the angle bracket.
Removing the appliance
WARNING
Risk of injury!
Components inside the appliance
may have sharp edges.
▶
Wear protective gloves.
1.
Disconnect the appliance from the
power supply.
2.
Remove the flue duct.
3.
Loosen the exhaust air lines.
4.
Remove the grease filters.
To avoid causing damage, do not
bend the grease filters.
5.
Unscrew in the screws for the ap-
pliance bracket slightly.
Do not loosen them fully.
6.
Remove the appliance.
7.
Remove the angle bract for the
flue duct.
