Bosch DA50 SensorSecure, Руководство по эксплуатации

Страница: 15 / 128

15
B O S C H
* Model dependent
EN
G
L
ISH
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button (2) repeatedly with pauses of
at least 5 seconds.
6. Ironing without steam

See the lealet sides
This enables the iron to be used for dry
ironing.
Set steam regulator (3) to the position.
DripStop
7. Drip protection *

See the lealet sides
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
8. Spray

See the lealet sides
This can be used to remove stubborn
wrinkles.
Do not use the spray function with silk.
9. “SensorSecure” function

See the lealet sides
The “SensorSecure” function makes the iron
heat up only while ironing.
Thus, safety and saving energy get
increased.
1. Plug in the iron.
2. “SensorSecure” light (15) lashes while
resting, and will show a continuous light while
ironing.
3. If the iron is resting for more than 12 seconds,
the iron will stop heating automatically.
4. Once ironing is restarted, the iron will heat up
again.
Initial heating up process: it is not necessary
to grip the handle until the iron heats up to the
set temperature. Once reached such
temperature, the pilot light (13) goes off.
10. After ironing

See the lealet sides
1. Switch the steam regulator (3) from to “max”
and back again several times (self- cleaning).
2. Empty the tank. Hold the iron with the point
down and shake lightly.
3. Store standing on the rear, not on the base.
4. Do not wrap the power cord (14) too tight!
Tips to help you save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
1. Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the label
on the garment.
2. Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
3 Only use steam if necessary. If possible, use
the spray function instead.
Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the
iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the ‘iron dry’
program.
4. If the fabrics are damp enough, turn off the
steam regulator (3) completely.
5. Stand the iron upright during pauses. Resting
it horizontally with the steam regulator on
generates wasted steam.
Cleaning & maintenance

See the lealet sides
E
Attention! Risk of burns!
Always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. If the iron is only slightly soiled, pull out the
plug and allow the soleplate (7) to cool down.
Wipe the housing and the soleplate with a
damp cotton cloth only.