D9131A
Event Description and Troubleshooting
D9131A User's Guide
© 2002 Bosch Security Systems
Page 5
34584G
2.0
Event Descriptions and Troubleshooting
The following events and their respective descriptions are listed in alphabetical order. Your system may not display all
of the events. For detail in the cause of events, see your
Security System
Owner’s Manual
.
Event
Description
Access Granted
A card access holder has been granted access at the point specified.
AC Failure
AC power to the security system is interrupted. Check the plug-in transformer and the
circuit breaker.
AC Restoral
AC power to the security system has been restored.
ALARM
-
Door Open
An access door has been held open beyond the allowed time while the area was armed.
Alarm Report
Alarm at device in area specified. This event also reports Cross Point Alarms, including
Cross Group (CG:##) information.
All Points
Tested
All points have been tested while in the Service Walk Test, Fire Walk Test, or Walk Test
mode.
Bad Call To RAM
System tried to call Remote Account To Ram Manager (RAM) and failed. Call your security
company.
Battery Low
Security system battery is low. Replace the battery.
Battery Missing
Security system battery is disconnected or has discharged. Reconnect the battery; call for
service.
Battery Restore
Security system battery has recharged.
Cancel Alarm
User with reported ID canceled an alarm from the area specified.
Card Assigned
An access card/token was added to the system.
Command Bypass
Device specified is bypassed.* System will not respond to faults at this point.
Closing Early
User armed area earlier than expected.
Closing Late
User armed area later than expected.
Closing Report
User with reported ID armed area.
Comm Failure
Security system could not communicate using the phone number reported. Call for service.
Date Changed
User with reported ID changed the date in the security system.
Door Closed-
Restoral
An access door in the area specified restored to normal after a
Door Left Open
event
has occurred.
Door Cycled
An access door in the area specified was cycled.
Door Left Open
The door specified has been left open past the programmed time.
Door Locked
An access door in the area specified was locked for normal operation.
Door Secured
An access door in the area specified was secured, which prohibits access.
Door Unlocked
An access door in the area specified was unlocked allowing free access.
Duress
User with reported ID manually initiated a special alarm in the area specified.
Early to Open
User disarmed area earlier than expected. If the entire security system is being disarmed,
the previous state of security system is indicated. If just one area is being disarmed, no
previous status is indicated.
Extra Point
Area specified reports an unprogrammed device. Call for service.
Extn Close Time
User with reported ID extended area’s closing time to that specified.
Fail To Close
Area failed to arm within your programmed closing window.
Fail To Open
Area failed to disarm within your programmed opening window.
F Close Early
User with reported ID force armed* specified area later than expected.
F Close Late
User with reported ID force armed* specified area later than expected.
F Close Pr Dlay
User with reported ID force armed* perimeter with entry/exit delay.
F Close Pr Inst
User with reported ID force armed* area perimeter with no delay time.
Fire Alarm
Fire Alarm at device specified.
Fire Cancel
See
Cancel Alarm.
Fire Restoral
The fire trouble or alarm event at the device specified has been restored.
