D1265
|
Owner's Manual | Part II: System Commands
Bosch Security Systems, Inc. | 9/10 | F01U169130-02
25
6.
Move through this list by pressing the
Next Pt
button.
The display changes to show the information for
that point.
Press the
Exit
button to return to the
### points
remain to be tested
screen before continuing
with the walk test.
7.
When all points have been tested,
0 points
remain to be tested
is shown.
Press the
Exit
button.
The display momentarily shows
All points have
been tested
.
The display then shows idle text.
Reset Sensors (CMD + 4 + 7)
Description
Detection devices, such as smoke detectors and shock
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them.
Using Reset Sensors
1.
Ensure the display shows disarmed idle text.
2.
Press the
CMD
button. The display shows
*System Command*
.
3.
Press the
4
button, followed by the
7
button.
If you prefer, you might use the function
list in place of Steps 2 and 3 to initiate
this function.
Press the
Menu
button to enter the
function list.
Press the
Next
button repeatedly.
When you reach the
Reset Sensors
button, press it.
4.
The display shows for approximately 15 sec.
While the sensors reset, the keypad resets
before it returns to idle text.
If you enter this function and the detector or sensor
resets momentarily, but then returns to a faulted
condition, the conditions causing the activation might
still be present or the detector might be faulty. Check
to be certain that there is no smoke, fire, or other
danger present. If you can’t reset the detector or
sensor, contact your security company.
