Bosch Compress 3000 DW FI Series, Инструкция по установке и эксплуатации

Страница: 11 / 32

6 720 809 134 (2013/09) Compress 3000 DW FII
Installation | 11
with the weight distributed equally over its 3 adjustable
feet).
To ensure faultless operation and easy access to all
components and connections for service and maintenance,
maintain the minimum clearances specified in Fig. 6.
Fig. 6 Recommended minimum clearances (mm)
5.2 Installing the appliance
▶ Remove the foil and external protective packaging.
▶ Lift the appliance from its pallet and position it on its final
plinth.
▶ To correctly align the appliance at the installation location,
adjust the height of the adjustable feet.
▶ Assure correct positioning of all temperature sensors.
Fig. 7 Temperature sensor at the top of the cylinder
Fig. 8 Temperature sensors ( evaporator plates + air inlet)
If the appliance only has one duct (inlet or
outlet duct), its operation may create
negative or positive pressure in the
installation room. If other burners are
already installed in the same place, please
bear in mind that the appliance requires a
clearance of at least 220 cm
2
for the air inlet
and outlet in order to operate correctly.
Note : The clearance of 220 cm
2
is required
for the correct functioning of the heat pump
only. In addition, you must ensure that the
burner has the necessary clearance.
500
400
2200
430
6720804054-17.1V
To ensure that the system operates
faultlessly and the condensate drains
correctly, the appliance must be aligned
vertically. The appliance must not tilt more
than 1°, preferably in the direction of the
condensate drain.