11.
Assembly
Combination Square Must Be True
Checking Combination Square
1. Position square and
draw a light line
2. Flip square
(shown in dotted position)
3. Check edge of flipped
square against the drawn line.
There should be no gap or
overlap at the bottom end.
drawn line
3/4" board with
straight top edge
no gap or overlap
Attaching loose parts
To
avoid
possible
injury,
disconnect plug from power
source before performing any assembly,
adjustments or repairs.
Storing the 4/6mm Hex Key
There is a storage location on the saw to store the
4/6mm hex key.
Insert the long leg of the hex key through the slotted
hole on the base of the saw and short leg of the hex
key through the rubber grommet as shown in figure 1.
NOTE: The 4/6mm hex key is needed to change the
blade and to make tool adjustments.
Grommet
4/6mm
Hex Key
WARNING
!
FIG. 1
BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 11
