Cleaning and maintenance
en
21
■
Cleaning with a jet of water is
prohibited.
Drum
Wipe the inside of the rubber seal dry
with a cloth. Leave the washing machine
door open in order that the drum can
dry. Use chlorine-free cleaning agents
and not steel wool.
Descaling
Note:
Make sure that there is no
laundry in the machine.
Descaling should not be necessary if
the detergent is measured out correctly.
However, if it is required, follow the
manufacturer's instructions for the
descaling agent. Suitable descalers can
be obtained via our website or from our
after-sales service.
Detergent drawer and housing
If the washing machine contains
detergent or fabric softener residues:
1.
Pull out the detergent drawer. Press
down the insert and fully remove the
drawer from the housing.
2.
To remove the insert, push the insert
up from below with your finger.
3.
Clean the detergent dispenser tray
and insert with water and a brush,
and dry it. Also remove any
detergent or fabric softener residues
in the housing.
4.
Fit the insert and lock it in place
(push the cylinder onto the guide
pin).
5.
Push in the detergent drawer.
Note:
Leave the detergent drawer open
so that any residual water can
evaporate.
Detergent solution pump
blocked
:
Warning
Risk of scalding!
When you wash at high temperatures,
the detergent solution gets very hot. If
you come into contact with the hot
detergent solution, you may be scalded.
Allow the detergent solution to cool
down.
1.
Turn off the water tap so that no
more water can flow in and has to be
drained via the detergent solution
pump.
2.
Switch off the appliance. Pull out the
mains plug.
3.
Open and remove the service flap.
4.
For models with a drain hose:
Take the drain hose out of the
retainer.
Remove the sealing cap; allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drain hose in the retainer.
