F 016 L70 560 | (25.11.08)
Bosch Power Tools
48
| English
n
Engage the safety lock
7
by moving the button as
shown.
o
Using a 5 mm hex wrench socket key (not provided) to
remove the blade screw
10
which secures the blade.
Remove spacer
11
.
p q
Remove the blade
2
as shown.
Be careful not to al-
low any foreign matter to become attached to the blade
gear and do not damage it.
r s
Insert blade
2
as shown. Ensure that the blade
2
has
located in the transmission link
12
.
t
Rotate the blade
2
to the fully open postion. Check the
blade
2
location by gently pulling. If the blade
2
is correct-
ly located then blade cannot be removed.
f
Incorrect location of the blade will damage the ma-
chine.
u
Refit spacer
11
. Ensure spacer
11
is located through
fixed blade and moving blade.
Refit the blade screw
10
and tighten it by using a 5 mm
hex wrench socket key (not provided). Do not overtight-
en.
f
Ensure replacement parts fitted are Bosch approved.
After Pruning/Storage
f
Warning! Switch off and engage the safety lock 7.
f
Always wear protective gloves when using, adjusting
or cleaning the machine.
Clean the exterior of the machine thoroughly using a soft
brush and cloth. Do not use water, solvents or polishes.
Remove all debris.
OBJ_BUCH-894-001.book Page 48 Tuesday, November 25, 2008 2:22 PM