Bosch AUTODOME IP starlight 5100i, Руководство пользователя

Страница: 37 / 80

AUTODOME IP starlight 5100i Camera | en 37
Bosch Security Systems
User Manual
2020-11 | draft 0.9 |
– Off : bit rate optimization is disabled
– Maximum quality
– High quality
– Medium
– Low bit rate
– Minimum bit rate
Maximum bit rate
This maximum bit rate is not exceeded under any circumstances. Depending on the video
quality settings for the I- and P-frames, this fact can result in individual images being skipped.
The value entered here must be at least 10% higher than the value entered in the
Target bit
rate field. If the value entered here is too low, it will be adjusted automatically.
Averaging period
Select the appropriate averaging period as a means of stabilizing the long term bit rate.
Target bit rate
To optimize use of the bandwidth in the network, limit the data rate for the device. The target
data rate should be set according to the desired picture quality for typical scenes with no
excessive motion.
For complex images or frequent changes of image content due to frequent movements, this
limit can temporarily be exceeded up to the value entered in the
Maximum bit rate field.
Note : You can change the value in this field only if you select a duration in the field Averaging
period . If you do not select an Averaging period , then the field Target bit rate is greyed out.
Frame rate
Set the desired value using the slider.
Note: A higher frame rate makes motion sequences smoother but requires more disk space. A
lower frame rate, achieved by skipping frames, requires less disk space but makes motion
sequences less smooth.
Video resolution
Select the desired resolution for the video image.
Note : The value in this field adjusts the resolution for SD streams only.
Advanced settings
If necessary, use the expert settings to adapt the I-frame quality and the P-frame quality to
specific requirements. The setting is based on the H.264 quantization parameter (QP).
I-frame distance
Use the slider to set the distance between I-frames to Auto or to between 3 and 255 . An entry
of 3 means that every third image is an I-frame. The lower the number, the more I-frames are
generated.
Note that the values supported depend on the GOP structure setting. For example, only even
values are supported with IBP; if you have selected IBBP, only 3 or multiples of 3 are
supported.
Allow enhanced prediction
This function allows for multiple references in H.264 and H.265 streams, which can reduce
bitrate. Some decoders do not support this feature and therefore can be disabled.
Min. P-frame QP
This parameter allows you to adjust the image quality of the P-frame and to define the lower
limit for the quantization of the P-frames, and thus the maximum achievable quality of the P-
frames. In the H.264-protocol, the Quantization Parameter (QP) specifies the degree of
compression and thus the image quality for every frame. The lower the quantization of the P-