Bosch AUTODOME IP starlight 5000i, Руководство по установке

Страница: 20 / 34

20 en | Installing an In-ceiling Camera in a Suspended Ceiling AUTODOME IP starlight 5000i
2020-07 | 1.3 |
Installation Manual
Bosch Security Systems
8.4 Securing the Camera to the Ceiling
1. Connect the cables from the ceiling to the cables on the camera. Refer to the chapter
Connection for more information.
2. Insert the camera (without the trim ring / bubble enclosure) into the hole in the ceiling.
Ensure not to pinch the cables.
3. Turn each fastening screw to secure the clamps in the ceiling.
3×
4. Tighten the clamps using the Phillips screwdriver to secure the housing to the ceiling.
!
Warning!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
5. Place the trim ring / bubble enclosure in position over the camera block, aligning the
three (3) screws. Tighten the screws firmly to secure the trim ring / bubble enclosure to
the in-ceiling bracket.