Bosch AutoDome 600 Series, Руководство по установке

Страница: 66 / 92

66 en | Installing the In-Ceiling Mount AutoDome 600 Series Analog PTZ Camera
F.01U.215.782 | 1.0 | 2011.04 Installation Manual Bosch Security Systems, Inc.
The following table summarizes the pin connectors and their function:
Table 4.1 Interface Box Wire Terminals
4.7 Prepare Bubble
The inside of the housing contains packing material to safeguard the camera during shipping.
You must remove the packing material before attaching the in-ceiling housing to the interface
box.
To remove the Bubble:
1. Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or
smaller Phillips screwdriver until the bubble can rotate freely.
2. Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from
the In-Ceiling Housing. See the figure below for an illustration.
Figure 4.10 Bubble Release Screw
3. Remove the foam inserts surrounding the camera module.
4. If you plan to use the RS232 or the RS485 protocol to control the dome, refer to either
Section 5.4.2 Controlling the AutoDome via the RS232 Protocol, page 74 , or
Section 5.4.3 Controlling the AutoDome via the RS485 Protocol, page 75 , for instructions.
Then, proceed to the next step.
5. Place the bubble over the Camera Module, and align it until it settles.
No. Connector Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7
P103 Alarms In Alarm 3 Alarm 4 Alarm 5 Alarm 6 Alarm 7 AGND
P102 Alarms Out Alarm 1 Alarm 2 Alarm 3 GND
P104 Analog Relay Relay
N.O.
Relay
COM
Relay
N.C.
Earth Alarm 1 Alarm 2 Ground
P105 Data In/Out C-
(BiPhase)
C+
(BiPhase)
Earth
Ground
RXD (+)
(RS-232/485)
TXD (-)
(RS-232/485)
Signal
Ground
P101 24 VAC Line Earth Neutral
J102 Video BNC Connector Input
J101 UTP/Ethernt
(Ethernet for VG5
700 Series only)
Connector Input
WARNING!
24 VAC Class 2 power supply only.