Bosch ALS 2400, Оригинальное руководство пользователя

Страница: 13 / 252

English | 13
Bosch Power Tools F 016 L81 594 | (27.7.16)
turer. See the operating instructions
for the order no. and types.
 Never touch the mains plug with wet
hands.
 Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
 The extension lead must have a cross
section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.
Electrical Safety
 Motor Protector fitted! Motor fit-
ted with safety overload protec-
tion. If motor stops working, allow
a few minutes to cool, before re-
starting.
 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is entangled.
 If a cord becomes damaged during
use, disconnect the supply cord
from the mains immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– 1.0 mm
2
: max. length 40 m
– 1.5 mm
2
: max. length 60 m
– 2.5 mm
2
: max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
 WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must be
of watertight construction and in-
tended for outdoor use.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
For products
not sold in GB :
WARNING: For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
OBJ_BUCH-2968-001.book Page 13 Wednesday, July 27, 2016 9:16 AM