Bosch Advanced Aquatak 150, Оригинальное руководство пользователя

Страница: 17 / 300

3 600 … HA7 7.. HA7 8..
Vibration total values a
h
(triax vector sum) and uncertainty K determined accord-
ing to EN 60335-2-79
– Vibration emission value a
h
m/s
2
3.2 2.9
– Uncertainty K m/s
2
1.0 1.0
Mounting and Operation
Action Figure Page
Delivery scope A 282
Adjusting the Handle B 283
Connecting high pressure wa-
ter supply hose/nozzle C 283
Connecting to the water supply D 284
Switching On and Off E – F 284
Clean the water filter G 285
Clean nozzle H 285
Connecting high pressure gun
to lance I 285
Tube Assembly J 286
Connect detergent bottle K 286
Variable Fan lance
Connecting high pressure gun
to lance
Adjust water jet L 287
Roto lance
Connecting high pressure gun
to lance
Adjust water jet M 288
Gun storage N 289
Storage O 289
Transport P 290
Selecting Accessories Q 291
Switching on
For Your Safety
Warning: Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Contact your Bosch Ser-
vice Centre for details. If in doubt contact a qualified electri-
cian or the nearest Bosch Service Centre.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
– 2.5 mm
2
– max length 25 m
Note: If an extension cable is used it must be earthed and
connected through the plug to the earth cable of your supply
network in accordance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest
Bosch Service Centre.
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and
socket must be of watertight construction
and intended for outdoor use.
The connections (plugs and sockets) should be kept dry and
off the ground.
For increased electrical safety use a Residual Current Device
(RCD) with a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
If the supply cord is damaged, it must be replaced by a
Bosch Service Centre.
For products
not sold in GB :
Warning: For your safety, it is required that the plug at-
tached to the product is connected with the extension cord.
The coupling of the extension cord must be protected
against splash water, be made of rubber or coated with rub-
ber. The extension cord must be used with a cable strain re-
lief.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
u
Products that are only sold in AUS and NZ: Use a resid-
ual current device (RCD) with a nominal residual current
of 30 mA or less.
Operation
u
To prevent damage to the appliance, do not allow it to
operate dry.
Starting
Attach water supply hose (not supplied) to the mains water
supply and machine.
Connect the product to the mains supply ensuring that the
mains switch is in the off position.
Open water tap.
English | 17
Bosch Power Tools F 016 L81 291 | (13.07.2018)