15
Attaching The Table Top
Locate 4 remaining 45x45 gussets. Then remove the
alignment tabs from both sides of each gusset.
Remove the template between the underside of the
table top and profiles.
Locate the 4 mounting screws and 4 flat washers that
came with the table top (purchased separately). Then
use that hardware to attach the gusset to the tabletop
as shown in the inset drawing on Figure 8.
Locate 4–T-bolts and 4–M8 flange nuts. Then start a
flange nut onto each T-bolt just 1 or 2 turns.
Slip prepared T-bolt/flange nut combinations through
the slot in the gusset and tighten the flange nut.
Attach the gussets to the table frame at the other 3
locations as shown in Figure 8.
Locate 2–45x60 end caps and place them on the
exposed ends of the 45x60 profiles. Tap lightly into
place with a soft mallet.
If you do not intend to use Accessory Uprights
(purchased separately), place 2–45x90 end caps on
the exposed ends of the 45x90 profile at this time.
45x45
Gusset
45x45
Gusset
45x60
End Cap
45x90
Profile
45x60
Profile
45x60
End Cap
45x90
End Cap
Table Top
MountingScrew
Flat Washer
INSET
T-bolt
and
Flange Nut
Figure 8
