Bosch 7 735 500 791, Инструкция по установке и обслуживанию для подрядчика

Страница: 26 / 64

W 300-5 P – 6 720 821 103 (2018/10)
26
About the product
2 About the product
2.1 Intended use
The DHW cylinder is designed for heating and storing potable water.
Please observe national, regional, and local codes, regulations,
guidelines and standards for potable water.
Install this DHW cylinder only in sealed unvented systems.
Any other purpose is considered improper use. Any resulting damage
from prohibited usage is excluded from liability.
2.2 Data plate
The data plate is located at the top rear of the DHW cylinder and includes
the following details:
2.3 Supplied parts
• Hot water cylinder
• Installation and maintenance instructions
2.4 Specifications
Requirements for potable
water Unit
Water hardness, min. ppm
grain/US gallon
°dH
36
2.1
2
pH value, min. – max. 6.5 – 9.5
Conductivity, min. – max. μS/cm 130 – 1500
Table 2 Requirements for potable water
Item Description
1
Model designation
2 Serial number
Table 3 Data plate
3 Actual capacity
4 Standby heat loss
5 Volume heated by immersion heater
6 Year of manufacture
7 Corrosion protection
8 Max. DHW temperature, cylinder
9 Max. flow temperature, heat source
10 Max. flow temperature, solar
11 Connected electrical load
12 Heating water heat input
13 Heating water flow rate for heating water heat input
14 Output volume at 40 °C electrically heated
15 Max. operating pressure on the domestic hot water side
16 Highest design pressure
17 Max. operating pressure on the heat source side
18 Max. operating pressure, solar side
19 Max. operating pressure on the domestic hot water side, CH
20 Max. test pressure on the domestic hot water side, CH
21 Max. DHW temperature with electric heating
Item Description
Table 3 Data plate
Unit W 300-5 P W 400-5 P
General information
Dimensions

Fig. 1, page 55
Tilt height mm 1655 1965
Minimum room height for anode replacement mm 1850 2100
Connections

Tab. 5, page 27
Connection size, DHW DN R1" R1"
Connection size, cold water DN R1" R1"
Connection size, circulation DN R¾ " R¾ "
Inner diameter, test point, cylinder temperature sensor mm 19 19
Dry weight (excluding packaging) kg 105 119
Total weight when filled kg 405 509
Cylinder capacity
Useful capacity (overall) l 300 390
Usable DHW volume
1)
with DHW outlet temperature
2)
:
45 °C l 429 557
40 °C l 500 650
Standby heat loss in accordance with DIN 4753 Part 8
3)
kWh/24h 1.94 2.12
Maximum flow rate, cold water inlet l/min 30 39
Maximum DHW temperature °C 95 95
Maximum operating pressure, potable water bar
(positive)
10 10
Highest design pressure (cold water) bar
(positive)
7.8 7.8
Maximum DHW test pressure bar
(positive)
10 10
Heat exchanger
Content l 8.8 12.1
Surface area m
2
1.3 1.8
Performance factor N
L
according to DIN 4708
4)
NL 7.8 12.5
Table 4 Dimensions and specifications (

Fig. 1, page 55 and Fig. 3, page 56)