Bosch 3 601 J3A 300, Оригинальное руководство пользователя

Страница: 28 / 368

28 | English
1 609 92A 5C4 | (04.03.2020) Bosch Power Tools
Removing the Battery
The battery (5) is equipped with two locking levels to
prevent the battery from falling out if the battery
release button
(6) is pressed unintentionally. As long as
the battery is inserted in the power tool, it is held in
position by means of a spring.
To remove the battery (5) , press the release button (6)
and pull the battery out of the power tool. Do not use
force to do this.
Battery charge indicator
The green LEDs on the battery charge indicator indicate
the state of charge of the battery. For safety reasons, it
is only possible to check the state of charge when the
power tool is not in operation.
Press the button for the battery charge indicator
or to show the state of charge. This
is also possible when the battery is removed.
If no LED lights up after pressing the button for the
battery charge indicator, then the battery is defective
and must be replaced.
Battery model GBA 18V...
LEDs Capacity
3× continuous green light 60−100 %
2× continuous green light 30−60 %
1× continuous green light 5−30 %
1× flashing green light 0−5 %
Battery model ProCORE18V...
LEDs Capacity
5× continuous green light 80−100 %
4× continuous green light 60−80 %
3× continuous green light 40−60 %
2× continuous green light 20−40 %
1× continuous green light 5−20 %
1× flashing green light 0−5 %
Fitting protective equipment
 Remove the
battery from the power tool before carrying out work on
the power tool (e.g. maintenance, changing tool, etc.).
The battery should also be removed for transport and
storage.
There is risk of injury from unintentionally
pressing the on/off switch.
Note: If the grinding disc breaks during operation or the
holding fixtures on the protective guard/power tool
become damaged, the power tool must be sent to the
after-sales service immediately; see the "After-Sales
Service and Application Service" section for addresses.
Protective guard for grinding
Place the protective guard
(10) on the spindle collar. Adjust
the position of the protective
guard
(10) to meet the
requirements of the operation.
Lock the protective guard
(10)
by tightening the locking screw
(9) using the hex key (4) .
 Adjust the protective guard (10) such that sparking in
the direction of the operator is prevented.
Note: The coding cams on the protective guard (10)
ensure that only a protective guard that is suitable for
the power tool can be fitted.
Protective guard for cutting  Always use the
protective guard for cutting (16) when cutting bonded
abrasives.
 Provide sufficient dust extraction when cutting
stone.
The protective guard for cutting (16) is fitted in the same
way as the protective guard for grinding (10) .
Extraction guard for cutting with a guide block
The extraction guard for cutting with a guide block (24)
is fitted in the same way as the protective guard for
grinding
(10) .
Side handle  Do not operate your power tool
without the side
handle (7) .
Screw the side handle (7) on the left or right of the
machine head depending on how your are working.
Hand guard  Always fit the hand guard (18) when
working with the rubber sanding plate (19) or with the
cup brush/disc brush/flap disc.
Attach the hand guard (18) to the side handle (7) .
Fitting the abrasive tools

Remove the battery
from the power tool before carrying out work on the
power tool (e.g. maintenance, changing tool, etc.). The
battery should also be removed for transport and
storage.
There is risk of injury from unintentionally
pressing the on/off switch.
 Do not touch grinding and cutting discs until they
have cooled down.
The discs can become very hot
while working.