TRIGGER "ON-OFF" SWITCH
To turn the tool “ON” squeeze the trigger
switch. To turn the tool “OFF”, release the
trigger switch, which is spring loaded and will
return to the “OFF” position automatically.
To increase switch life, do not turn switch on
and off while tool is under load.
VARIABLE SPEED DIAL
Your tool is equipped with a variable speed
dial. The impact rate (BPM) and rotating
speed (RPM) can be varied according to the
type of work being performed by setting the
variable speed dial to the selected setting.
The chart below will help you to determine
which setting to use for your application.
However, a pre-test will determine the best
speed setting, as the chart is intended only
as a guide. Once the proper setting is
determined the impact rate and rotating
speed is kept constant by means of the
"Electronic Feedback Circuitry". The variable
speed dial can be adjusted while the motor is
running with the tool free from work, allowing
the operator to adjust the impact rate and
rotating speed according to the actual
application.
CHIPPING (DEMOLITION)
DRILLING HOLES
ELECTRONIC FEEDBACK CIRCUITRY
(EFC)
The internal electronic feedback system
provides a "soft start", which will reduce the
stresses that occur from a high torque start.
The system also helps to keep the pre-
selected impact rate and rotating speed
virtually constant between no-load and load
conditions.
INSTALLING ACCESSORIES
Clean the insert shank end of the accessory
to remove any debris, then lightly grease with
a light oil or lubricant.
Insert accessory into the tool holder through
the dust shield, while twisting and pushing
inward until it locks automatically into place.
Pull outward on the accessory to be certain it
is locked into the tool holder (Fig. 2).
NOTE: The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING ACCESSORIES
Accessories may be hot after
use. Avoid contact with skin
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull and hold
locking sleeve backward and pull bit forward.
All accessories should be wiped clean after
removing.
-7-
Operating Instructions
Area of application
Control setting
Plaster work
1 - 2
Removing tiles
3
Brick work
4
Concrete
5 - 6
Lower speeds
Higher speeds
Accurate starts
Faster penetration
Minimize breakouts
when the bit exits
the material.
!
WARNING
FIG. 2
LOCKING SLEEVE
BM 1619929472 2-05 2/17/05 11:52 PM Page 7
