7. The ice-making cycle will last approximately 7-15
minutes, depending on the ambient temperature and
water temperature.
8. The ice-making cycle starts with water being pumped
into the ice tray situated below the evaporator. Over the
next 7-15 minutes ice forms on the evaporator. Once this
has completed, the ice tray will tilt backwards and the
remaining water in the ice tray is drained back into the
water reservoir. The ice cubes are then dropped from the
evaporator and pushed forward into the ice basket by the
ice shovel. The ice tray will automatically move back into
position under the evaporator and start the next cycle.
9. The “ICE FULL” indicator will light up when the ice
basket is full and then the ice maker will stop the
ice-making cycle automatically. Gently remove the ice
from the ice basket with the ice scoop. About 7.5
seconds later, the ice maker will restart its ice making
function automatically.
10. The “ADD WATER” indicator will light up when the
water reservoir is lack of water and the ice-making cycle
will stop automatically. At that time, remove the ice
basket and add water to the water reservoir, and then
press “ON/OFF” key again to restart the ice-making
cycle.The appliance will start working automatically after
about 20minutes if the operator forgets to restart the
appliance after refill.
11. When you have got your desired amount of ice, stop
the ice making cycle by pressing the “ON/OFF” key and
unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
13. Allow the ice maker to reach room temperature.
USING YOUR ICE MAKER
5. The appliance must be placed on a dry and level
surface with sufficient ventilation, far from heat sources
such as ovens, heaters and corrosive gases.Leave about
a 6-inch (15cm) clearance on all sides of the ice maker
for proper ventilation.
6. Do not fill the water reservoir with hot water. This may
damage the ice maker. It is best to fill the water reservoir
with water of room temperature or lower.
7. Do not use the appliance at a very cold environment
(lower than 5
℃
).
8. Clean the appliance by following the operation of
“CLEANING AND MAINTENANCE” before operate.
1. Ensure that the drain plug at the bottom of water
reservoir is closed well.
2. Plug the ice maker into the wall outlet, the “ICE”
indicator blinks.
NOTE: Please make the ice maker be rested for 30
minutes before plug if it has been moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
NOTE: Do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press “ON/OFF” key, and the “ICE”indicator lights
solidly. At that time, press ”SELECT” key to select the ice
size. If need to clean the appliance, press “SELECT” key
to select “CLEAN” function under standby mode.
