08
EN
– do not use in case of intolerance of one of the materials used
– no re-use – this medical aid is intended for treating one patient
– whilst wearing the support, please neither use any creams nor ointments
on or around it as they can destroy the material.
Fitting instructions
When you receive your BORT Generation Back Support, the front fastener is
closed. Open it fully. The pad which is split into two in the back area must
be positioned with the respective wider part of the pad in the direction of the
head. Place both pads respectively on the outer edge of the support cover.
Place the back support around the abdomen and close the BORT Generation
Back Support applying very little force, using the attached hand straps. In
order to close the BORT Generation Back Support fully, slip into the hand
straps and pull them forwards simultaneously and evenly, applying very little
force. Following this, attach the hand straps to the front fastener or the velour
surfaces at the side using the micro Velcro provided. Observe here that the
support is not closed too tightly. Within the course of this fitting process,
the BORT Generation Back Support is fully fitted to the anatomy of the body
and interlocks. If the lower part of the support ends with the hip-bend when
sitting, the support is correctly positioned.
Removal
To remove the support, loosen the pulley hand straps and then open the front
fastener.
Material composition
Polyamide (PA), elastane (EL)
The sewn in textile label provides the precise material composition.
