10
EN
4
Close the fasteners in the following order, always from the centre of the knee downwards, then from
the middle of the knee upwards:
1. Front fastener close to the knee on the lower leg
2. Front fastener close to the knee on the thigh
3. Rear fastener close to the knee on the lower leg
4. Fastener away from the knee on the lower leg
5. Fastener close to the knee on the thigh
6. Fastener away from the knee on the thigh
Whilst tightening the fastener, smoothen it in the tension direction with your free hand. This avoids twisting
the brace on the leg.
Important:
Let the patient try walking. Check for possible pressure, if required the brace frame can be
reshaped. Be careful not to damage the brace frame.
5
Setting the extension/flexion limit: if required, it can be necessary to restrict the scope of the brace’s
movement.
1. For this, remove the condyle pad
2. Remove the screw for the limit stop to be set
3. Remove the limit stop from the joint and insert the required angular degree
4. Fix the stop used with the screw provided
The following restrictions are available:
– Extension: 0°, 5°, 10°, 15°, 20° and 25°
– Flexion: 0° (180°), 30° 45°, 60°, 75° and 90°
Material composition
Frame pad: 60% EVA foam, 40% polyester
Fastening straps: 100% polyamide
Fastening straps pad: 74% polyurethane, 26% polyether
Cleaning information
Can be cleaned using mild detergents and lukewarm water. Close the Velcro fasteners in order to avoid
damaging items of clothing, for example. Air dry it and avoid heat.
Hand-washing Do not clean chemically Do not bleach Do not dry in a tumble dryer
Do not iron
Guarantee
The legal regulations of the country in which you acquired the product apply to the purchased product.
Please contact your specialist retailer if you suspect a warranty claim. Please clean the product before
submitting a warranty claim. If the enclosed instructions for use have not been properly observed, the
warranty may be impaired or cancelled. The warranty does not cover use of the product inappropriate for the
indication, non-observance of application risks, instructions and unauthorised modifications to the product.
