BorMann Pro BBS1560, Руководство пользователя

Страница: 5 / 13

EN
WWW.BORMANNTOOLS.COM
5
BELT TRACKING
The belt-tracking adjustment is set at the factory so that the abrasive belt will run true on
the drums. If, however, the belt should track to one side or the other, an adjustment can be
made by turning the tracking knob.
-Turning the knob clockwise will cause the belt to track to the right (towards the disc sander).
- Turning the knob counter-clockwise will cause the belt to track to the left side of the ma
-
chine.
TO TRACK THE SANDING BELT
1. Rotate the sanding arm to the desired position and tighten socket head screw to secure.
2. Turn power switch ON,
3. Note whether the belt tends to wander off its track, and to which side (left or right) of the
sander.
If the sanding belt does not move to either side, it is tracking properly. If the sanding belt
moves to the right (disc side of the sander), turn the tracking knob counter clockwise ¼ turn.
If the sanding belt moves to the left (away from the disc), turn the tracking knob clockwise
¼ turn.
4. Readjust tracking knob another ¼ turn, as necessary.
VI. Operation
WARNING :
Never touch the sand disc or belt while it is moving, do not touch the work piece after sanding, it could be very hot.Always wear safety
glasses when operating the sander.
CAUTION :
Always make sure the work table and the backstop are properly adjusted and secure before use.
ON/OFF BUTTONS
The ON/OFF buttons are located on the front of the sander.
1. Press the GREEN button (I) to turn the sander on.
2. Press the RED button (0) to turn the sander off.
If the power supply is interrupted for any reason, the unit will automati
-
cally switch off. When power is restored, simply press the GREEN button to
resume work.
BELT SANDING
HORIZONTAL AND VERTICAL SANDING
The sanding belt can be used in the vertical or horizontal position, depend
-
ing on operator needs and the workpiece.
To change from one position to the other:
1.Loosen the socket head screw using the 6 mm hex wrench provided.
2.Manually move the sanding belt to the desired angle and retighten the
socket head screw.