BorMann 037590, Руководство пользователя

Страница: 17 / 35

EN
WWW.BORMANNTOOLS.COM
17
Machine cleaning
Remove chips and saw dust with brush or vacuum cleaner from: setting devices, operating elements, motor vent slots, space below table insert.
Machine storage
DANGER: Store saw in such way that it can not be started by unauthorized persons, safeguard the saw with a padlock, m ake sure that nobody can get injured
by the stored machine.
CAUTION!
Do not store saw unprotected outdoors or in damp environment. Observe the permissible ambient conditions (see "Technical Specifications’).
Maintenance
Prior to every use
Remove saw dust and chips with vacuum or brush. Check power cable and power cable plug fordamage; ifnecessary have damaged parts replaced by a qualified
electrician. Check all moving parts to see thathey can move freely across their whole range of travel. Periodically, depending on operating conditions:
Check drive belt condition and tension, correct if necessary.
Check all screwed joints, retighten if necessary.
Check pull-back springs of the saw-head (the sawhead mustreturn by spring power to its upper starting position), replace if necessary.
Tips and Tricks
ACCESSORIES
- Vertical vise
- HEX Wrench
- Hex key
-Dust bag
For long stock use suitable supports on both sides of the saw.
Use auxiliary fence when sawing small cut-offs (this may be a suitable board,
fastened with four screws to the fence). When cutting warped stock, place the
convex side of the bow against the fence.
Do not cut stock standing on edge, always place it flat on the rotating table.
Keep the supporting surfaces clean in particular, remove resin residue with a
suitable cleaning and maintenance spray.
Repairs
Repairs to electric tools must be carried out by qualified electricians only! Electric tools in need of repair can be sent tothe service centre of your country. Refer
to the spare parts list for the address. Please attach a description of the fault to the electric tool.
Environmental Protection
The machine's packing can be 100% recycled. Worn out power tools and accessories contain considerable amounts of valuable raw and rubber materials, which
canbe recycled. These instructions are printed on paper produced with elemental chlorine-free bleaching process.
Trouble Shooting
In this section problems and faults are described which you may remove yourself. Ifthe measures detailed here do not solve the problem, see under "Repairs".
Danger!Many accidents happen particularly in connection with problems and faults. Therefore please note: Always unplug before servicing.Check that all safe -
ty devices are operational again after each fault service. Motor does not run. No mains voltage Check cables, plug, outlet and mains fuse. No cross-cut function
Transport locking pin engaged: ull transport locking pin out. Safety lock engaged: Actuate the safety lock. Only little sawing performance: Saw blade blunt (pos -
sibly tempering marks on blade body): Saw blade not suitable for material being cut (see chapter "Technical Specifications"); Saw blade warped. Replace saw
blade (see chapter "Maintenance"). Saw vibrates heavily: Saw blade warped: Replace saw blade (see chapter "Maintenance’). Saw blade incorrectly mounted:
Mount saw blade correctly (see chapter "Maintenance’). Saw squeals when starting : Drive belt tension too low: Retension the drive belt (see chapter "Main -
tenance - Drive belt tensioning'). Stiffness of rotating table. Saw dust build-up under rotating table: Remove saw dust.
XXXVII.