BorMann 035930, Быстрый старт

Страница: 5 / 10

EN
WWW.BORMANNTOOLS.COM
5
Abrasive pad replacement
CAUTION: DISCONNECT SANDER FROM POWER SOURCE.
1. Grasp the abrasive pad and the sander housing (clamping the pad to the housing), to prevent pad rotation.
2. Rotate the pad retaining nut, counter-clockwise and remove.
3. Lift off the large metal washer, and the abrasive pad
NOTE: When the abrasive pad, is lifted off the Sander: the abrasive back-up disc is exposed. Please note that this back-up disc is also covered with an abrasive
material. This abrasive material is ONLY used to prevent "slippage" between the back-up disc and the foam backed abrasive pad, it is NOT suitable for use as a
sanding abrasive. DO NOT USE THE SANDER WITHOUT A PROPER ABRASIVE PAD INSTALLED (to prevent severe damage to the work).
4. Position new abrasive pad to the back-up disc, making sure that the center hole in the abrasive disc is centered on the hub of the back-up disc.
5. Position the large metal washer the retaining nut to the Sander.
6. Rotate the retaining nut clockwise to hand tighten (while holding the abrasive pad).
Assemble for longer handle
Care and maintenance
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a dry place.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
If a fault cannot be rectified, return the mixer to an authorized dealer for repair.
Cleaning
Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible. Clean the unit by rubbing it with a clean cloth or blow it clean
using low-pressure compressed air.
We recommend that you always clean the unit immediately after using it.
Clean the unit regularly by rubbing it with a damp cloth and a little soft soap. Do not use cleaners or solvents; these will attack the plastic parts in the unit. You
must also ensure that water cannot get into the inside of the unit.
1350-1700mm