BorMann 035268, Руководство пользователя, Страница: 4 / 16

EN
WWW.BORMANNTOOLS.COM
4
Technical Data
Description of main parts
Assembly instructions
● Power: 1100W
● Impact Rate: 7 Joule
● HEX type: SDS max
● Weight: 6Kg
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these
changes significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you
hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be included in the
product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided
if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including
maintenance and special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
(1) Drill bit
(2) Part of SDS-MAX shank
(3) Turn Staff Armor
(4) Flex Sheath
(5) Orientation Staff Guard
(6) Winged Bolt
(7) Auxiliary handle
(8) Speed Adjuster Knob
(9) Power -ON Indicator
(10) Service Indicator
(11) Function Knob
(12) Cover
Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which specified on the name plate of the hammer.
2. Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the power switch is in ON position, the demolition
hammer will start operation immediately, which could cause a serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as
short as practicable.
1. Install and Removing the SDS-max bit (Fig.1)
CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect to the plug from the power receptacle.
Warning: Always wear gloves when changing accessories. The exposed may become extremely hot during operation.
NOTE!
When using tools such as Tine chisel, drill bits, etc., make sure to use the genuine parts designated by our company.
(1) Clean the bit shank and apply grease before inserting the bit.
(2) Insert the bit into the tool. Turn the bit with slight pressure, you can feel a spot where there is a hitch. At that spot, pull the flex sheath to the direction of
an arrow mark and insert the drill bit all the way until it hits the innermost end.
(3) Pull the bit to make sure it is locked completely.
(4) To remove the bit, fully pull the flex sheath in the direction of the arrow and pull out the tool.
2. Auxiliary handle (Fig.2)
Operate your power tool only with the auxiliary handle .
The auxiliary handle can be set to any position for a secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle in counter-clockwise direction and swivel the auxiliary handle to the desired position. Then retighten the bottom
part of the auxiliary handle by turning in clockwise direction.
Pay attention that the band of the auxiliary handle is positioned on the cover as intended for.
3. Install the Orientation Staff Guard (Fig.2)
(1) Loosen the winged bolt on the auxiliary handle, and insert the staff gauge into the mounting hole on the side handle.
(2) Adjust the staff gauge position according to the depth of the hole and tighten the winged bolt securely.
4. Regulating the number of rotations and hammering (Fig. 3)
This Rotary Hammer is equipped with a built-in electronic control circuit that can adjust and regulate the number of rotations and times of hammering. This
Rotary Hammer can be used by adjusting the speed adjuster knob, depending upon the contents of operation, such as boring holes into fragile materials,
chipping, centering, etc.