BorMann 034889, Быстрый старт, Страница: 8 / 15

EN
WWW.BORMANNTOOLS.COM
8
Pull the plug before starting any maintenance work on the machine.
-Use a damp cloth and a small brush to clean the plastic parts. Do not use cleaning products, solvents or sharp objects.
-Clear the ventilation openings and moving parts from deposits of dust at regular intervals using a soft brush or paintbrush.
-Only use accessories and spare parts recommended by the manufacturer. If the equipment should fail some day in spite of our quality controls
and your maintenance, only have it repaired by an authorised electrician.
Maintenance and Care
Care must be taken when handling this product. Dropping this power tool could have an effect on its accuracy and could also result in personal injury. This
product is not a toy and must be respected. Environmental conditions can have a detrimental effect on this product if neglected. Exposure to damp air can
gradually corrode components. If the product is unprotected from dust and debris, components will become clogged. If not cleaned and maintained correctly
or regularly the machine will not perform at its best.
Handling and Storage
At the end of the tool's working life or when it can no longer be repaired, ensure that it is disposed of according to national regulations. Contact your local
authority for details of collection schemes in your area. In all circumstances:
• DO NOT dispose of power tools with domestic waste.
• DO NOT incinerate.
• DΟ NOT dispose of as unsorted municipal waste.
Environmental Protection & Disposal
Important. When fitting a cutting disc the shaft screw must only be tightened so far that the disc is secure and cannot turn by itself. If you tighten the shaft screw
to much, the cutting disc may jump off the disc flange or the disc may fracture.
- Push the flange cover back again.
-Push the front cutting disc cover downwards again.
-The entire cutting disc cover will close.
Important: After fitting a new cutting disc allow the machine to run for approximately one minute before starting any cutting work. Do not stand in the cutting
direction of the machine 7 during this process. If the disc has an invisible fracture or some other type of damage that it not obvious, it will rupture in less than
one minute.
Dust extraction:
IMPORTANT:
1) Important. Not every dust extractor is suitable for metal chips since they may be very hot and in certain circumstances can cause a fire
2) Not every dust extractor is suitable for metal chips since they may be very hot and in certain circumstances can cause a fire.
1. Switch on/off
-The metal cross-cut saw can be started by pressing the ON/OFF switch.
-The metal cross-cut saw will be switched off again when
ON/OFF switch is released.
2.Working with the metal cross-cut saw - First secure your workpiece in the vice.
- Switch on the machine and wait until the motor has reached its maximum speed.
- Slowly press the saw head on the handle (1). - Guide the cutting disc through the workpiece with even, firm pressure.
- Prevent the cutting disc from fluttering or jumping. This will result in poor cutting results, premature wear or even to the fracture of the cutting disc.
- Do not reduce the cutting speed even at the end of the cutting process since the workpiece may otherwise becoming unnecessarily overheated which may
well result in unnecessary burr formation.
3. Cutting speed
Slow cuts: Less wear on the cutting disc GB (depending on the quality of the cutting disc);
the workpiece may tend to form burr and become discoloured due to overheating. Fast cuts: High wear on the cutting disc (depending on the quality of the
cutting disc); less burr formation and less discolouration on the workpiece since it does not become so hot.
Operating Instructions