BorMann 022329, Инструкция по эксплуатации, Страница: 5 / 10

EN
WWW.BORMANNTOOLS.COM
5
• To insert the gas pipe in the stove gas’s connector on the back of the stove and push it until the pipe is inserted up to the
connector for at least 2cm .
• Tighten the metal clamp in order to seal safely the rubber hose to the stove connector.
LPG Cylinder Assembly
• Before assembling the cylinder, turn the burner valve’s knobs clockwise until them reach the closed position.
• Place the gas cylinder in a stable and dry surface
• Connect the pressure regulator already assembled to the gas pipe to the LPG cylinder making sure you have correctly
inserted the seal gasket supplied with the cylinder.
• Always use the new gaskets supplied together with the LPG cylinder.
• Tighten the regulator to the cylinder to prevent gas leakage.
• Check that the gas hose is not twisting. In case, rotate the pipe in order that every twist or curve is eliminated and the tube
has a linear shape.
• Turn the cylinder’s valve knob until fully open in order to allow the gas LPG to feed the stove.
• Keeping the stove taps closed for five minutes and check does not spread out smell of gas before proceeding with the use of
the stove.
• To verify that the installation has been done successfully, pour soapy on the joints of every connection. Any leaking will be
well visible using this solution.
• Attention: Never use a flame to check the Gas leaking.
Using the stove
• Lightly press and turn counter-clockwise the burner valve’s knob according the burner you want use.
• Put a lighter close to the defined burner
• Wait until the burner is fully switch ON and adjust the flame by turning the knob clockwise or counter-clockwise according
your needs .
• To make the temporary shut-down of the burner , turn the knob clockwise to the OFF position.
• After cooking , or before storing the product, turn OFF the burner by turning clockwise the cylinder valve’s knob tilli s close
and wait for the complete extinction of the flame . then rotate also the burner valve’s knob to OFF position. This eliminates
residual gas inside the tube and in the stove as well .
• Wait until the stove is cold before moving or storing, at least 30 minutes.
LPG Cylinder Exchange
• If, while using, the burner goes OFF , needs to replace the cylinder .
• Turn OFF the cylinder and the burner’s knob to the close position before proceeding with the unscrewing of the pressure
regulator.
• To assembly of a new Gas cylinder, please follow the instruction indicate in the chapter LPG gas cylinder assembling, always
respecting the Safety Instructions .
Cleaning And Maintenance
• Regularly clean your Stove between uses and especially after extended periods of storage.
• Before proceeding with cleaning and maintenance of the product , make sure that the stove is properly cooled ; wait at least
30 minutes after the last use .
• Ensure that the cylinder valve and the burner’s valve are in the closed position . Remove the grid to perform the cleaning
more conveniently .
• Use a damp sponge to remove heavier dirt , a damp cloth and then a dry cloth are enough to clean and dry all surfaces .
• Never use abrasive substances , solvents or flammable .
• The only maintenance required for this equipment are the gas pipe and the cylinder. Always make sure that these
components are comply with current regulations and maintained in good working order . Always use the new gaskets
supplied with the cylinder to ensure the seal between regulator and cylinder
Storage
• Store your Stove in a cool dry place. Cover the burners with aluminum foil in order to prevent insects or other debris from
collecting in burner holes. If the Stove is to be stored indoors, the gas cylinder must be disconnected and left outside. The gas
cylinder should always be stored outside, in a dry, well-ventilated area, away from any sources of heat or ignition. Keep out of
the reach of children.