BorMann 020882, Руководство пользователя

Страница: 16 / 18

OPERATION
Hold the tool firmly, turn the tool on and then apply the wheel or disc to the workpiece.
In general, keep the edge of the wheel or disc
at an angle of about 15 to the workpiece
surface.
During the break-in period with a new wheel,
do not work the grinder in the B direction, or it
will cut into the workpiece. Once the edge of
the wheel has been rounded off by use, the
wheel may be worked in both A and B
directions.
(Fig. 5)
WARNING:
Fig. 5
• It should never be necessary to force the tool. The weight of the tool applies
adequate pressure. Forcing and excessive pressure could cause dangerous wheel
breakage.
• Continued use of a worn-out wheel may result in wheel explosion and serious
personal injury. Depressed center wheel should not be used after it has been worn
down to 75 mm (3") in diameter. Use of the wheel after this point is unsafe and it
should be removed from service and rendered unusable by intentional destruction.
- 7 -