DOCUMENT PART NUMBER
A-35963 Rev. B
INSTALLATION INSTRUCTIONS
Ford Mustang GT 5.0L
BORLA PERFORMANCE INDUSTRIES
500 Borla Drive
Johnson City TN, 37604-7523
805-986-8600
PAGE
6 of 7
Borla Performance Cat-Back
Exhaust System Installation
1. Orient components on floor referencing page-2 drawing.
2. Transfer both rubber isolators from factory exhaust to the Borla mid-pipes noting
the correct orientation. (See Fig. 6)
3. Slide the adapter pipes into the x-pipe assembly, using two 3” clamps fasten the
components together. (See Fig. 7)
4. SELECT COMPONENT TO INSTALL:
X-PIPE INSTALLATION: Install the factory band clamps onto the front pipes and
insert the inlets of the
X-pipe Assembly
into the band clamps. (See Fig. 8A) Do not
tighten the clamp bolts.
RESONATOR OPTION INSTALLATION: Install the factory band clamps onto the
front pipes and insert the inlets of the
Resonator Option
into the band clamps. (See
Fig. 8B) Do not tighten the clamp bolts.
5. Install the
R/H Intermediate Pipe Assembly
inserting the hanger hook into the
rubber isolator. (See Fig. 9)
6.
REPEAT STEP 5 for the
L/H Intermediate Pipe
Assembly.
NOTE: When you first start your vehicle after the installation of your new Borla Performance Exhaust
System, there may be some smoke and fumes coming from the system. This is a protective oil based coat-
ing used in the manufacturing of mandrel bent performance exhaust tubing. This is not a problem and
will disappear within a very short period of time after the exhaust has reached normal operating temper-
atures.
WARNING: Use extreme caution during installation. Torque all fasteners according to manufactur-
er’s torque values and tightening sequence. DO NOT use air impact tools to tighten fasteners on
Borla Performance
Exhaust
Systems. Use of such tools may result in bent flanges or gasket contact
areas leading to exhaust leaks.
6
7
8A
9
8B
