Borg & Overstrom 818, Руководство по установке и эксплуатации

Страница: 5 / 55

818 Sport Models
5
All Types
All B&O 818 Sport models are self contained machines with robust steel framed cabinets and attractively injection
moulded plastic front, side and top panels. There is sufficient space internally for most filters to be fitted behind
the right side panel.
An IEC Power Lead is supplied for connection to the IEC socket found on the rear of all models (An additional
Schuko type is supplied for the European market).
Optional Floorstanding Base Cabinet
A sturdy, steel-sided cabinet with an opening door and service access ports in the rear panel. Adjustable feet are
standard.
818 Cold and Ambient Model
Water is fed into the insulated Cold Tank under mains pressure. We strongly recommend fitting a Pressure
Reducing Valve is fitted to all supplies to regulate the pressure to 3.5 bar/355 kPa. Water bypasses the cold tank
for the ambient dispense option. The cold tank is chilled via the outer evaporation coil of the capillary controlled
refrigeration compression system.
Dispense is at inlet pressure via the DC current operated solenoid valves.
The Cold Temperature is thermostatically controlled via the adjustment screw on the back of the machine. This
setting is factory set and is not necessary to adjust in most cases (see Controls).
The Cold Tank can be drained via the lower of the two Drain Ports on the rear of the machine.
818 Cold and Sparkling Model
A Direct Chill cold water dispenser where water is used as the cooling medium in the Direct Chill tank. This is
automatically filled and controlled by the level control system upon installation. This tank is then chilled via the
outer evaporation coil of the capillary controlled refrigeration compression system.
Water is chilled as it passes through the coil immediately before dispense or being pumped under pressure into the
carbonator which it fitted inside the same coil. The carbonator is also level controlled and allows the sparkling
effect to occur through saturation with CO
2
.
The level control system also incorporates a leak detection device within the cabinet which switches the machine
off in the event of detecting water.
The Cold Temperature is thermostatically controlled via the adjustment screw on the back of the machine. This is
factory set and is not necessary to adjust in most cases (see Controls).
The Cold Tank can be drained via the upper of the two Drain Parts on the rear of the machine.