191
Fig. 6.1
Fig. 6.2
OVEN FITTING OUT
•
Assemble the wire racks to the oven
walls using the 2 screws (fig. 6.1).
•
Slide in, on the guides, the shelf and
the tray (fig. 6.2).
The rack must be fitted so that the
safety notch, which stops it sliding
out, faces the inside of the oven; the
guard rail shall be at the back.
•
To dismantle, operate in reverse
order.
Guard rail
Stop notch
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity
surface.
NOTE:
The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
Fire risk! Do not store flammable
material in the oven
Содержание CFBI901AN
