BORETTI CFBG903AN, Инструкция по монтажу и эксплуатации

Страница: 234 / 248

234
The gas connections are made on the
left or on the right (fig. 10.1) at the rear of
the appliance, in such a way that the pipe
never passes behind the cooker.
The end of the gas connection, whether
on the left or right, that is not being used,
must be closed by attaching a cap fitted
with a seal.
• Installation can only be carried out by a
qualified technician, and must conform
with the local regulations in force (NBN
Standard D 51-003).
• The surfaces next to the cooker must
either be made of a heat resistant
material, or must be covered by such a
material.
• Ventilation of the room - the combustion
of gas can only occur because there is
oxygen present in the air. The air must
therefore be able to be renewed, and the
products of combustion must be able to
be expelled. The volume of renewed air
must be at least 2m
3
/h for each kW.
Gases normally used can be grouped into
two main families:
- L i q u i d G a s : B u t a n e G a s ( G 3 0 ) ;
Propane Gas (G31)
- Natural Gas (G20/G25)
The cooker is supplied ready to operate,
using the type of gas which is indicated
on the label attached to it. Sometimes,
however, it may be necessary to change
from one gas to another.
Whatever type of gas the cooker is
designed for, the following procedures
must be followed:
• Connection to the gas supply.
• Replacement of the burners on the
cooking surface.
• Adjustment of the gas flow to the burners
on the cooking surface.
Ensure that the cooker is equipped for the
type of gas it is to be supplied with (see
label).
The gas supply circuit must conform to
the local regulations in force.
B)
CONNECTIONS TO THE GAS
SUPPLY FOR:
BE
Cat:
II
2E+3+