BORETTI BAMBINO, Руководство по эксплуатации

Страница: 37 / 42

NL
FR
D
EN
37
repeat step 3.
5. Adjust the heat by turning the needle valve
to the High /Low position.
6. To turn the barbecue ‘OFF’ turn the cylinder
valve or regulator switch to the ‘OFF’ posi-
tion and then turn the needle valve on the
appliance clockwise to the ‘OFF’ position.
Warning: If the burner fails to ignite, turn the
control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before at-
tempting to relight with ignition sequence.
Before cooking for the first time, operate the
barbecue for about 15 minutes with the lid
closed and the gas turned on HIGH. This will
“heat clean” the internal parts and dissipate
odour from the painted finish.
Clean your barbecue after each USE.
DO NOT use abrasive or flammable cleaners,
as it will damage the parts of the product and
may start a fire.
Clean in warm soapy water.
WARNING: Accessible parts may be very hot.
Keep young children away from the hot appli-
ance at all times (even while cooling down!). It
is recommended that protective gloves (e.g.
oven gloves) be used when handling particularly
hot components.
Cleaning and care
CAUTION:
AII cleaning and maintenance should
be carried out when the barbecue is cool and
with the fuel supply turned OFF at the gas cyl-
inder.
Cleaning
“Burning off” the barbecue after every use (for
approx 15 minutes) will keep excessive food
residue to a minimum.
Outside surface
Use mild detergent or baking soda and hot
water solution. Non-abrasive scouring powder
can be used on stubborn stains, then rinse with
water. If the inside surface of the barbecue lid
has the appearance of pealing paint, baked on
grease build-up has turned to carbon and is
flaking off. Clean thoroughly with strong hot
soapy water solution. Rinse with water and al-
low to completely dry.
NEVER USE OVEN CLEANER.
Interior of barbecue bottom
Remove residue using brush, scraper and/or
cleaning pad then wash with a soapy water so-
lution. Rinse with water and allow to dry.
Cooking grid
Use a mild soapy water solution. Non-abrasive
scouring power can be used on stubborn stains
then rinse with water.
Cleaning the burner assembly
Turn the gas OFF at the control knob and dis-
connect the cylinder.
Remove cooling grate.
Clean the burner with a soft brush or blow clean
with compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or
stiff wire (such as an opened paper clip).
Inspect burner for any damage (cracks or
holes). If damage is found, replace with a new
burner. Reinstall the burner, check to ensure
that the Gas valve orifices are correctly po-
sitioned and secured inside the burner inlet
(venturi).