16
1.
After putting through the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
Press "▲" or " " button to set your required temperature. (
Temperature can’t
be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low speed, medium
speed, high speed.
Operation guide
▲
Replacement of batteries in remote controller
●
During operation, point the remote control signal sender at the receiving
window on indoor unit.
●
The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
●
Signal may be interfered easily in the
room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during
operation.
●
Replace new batteries of the same model when replacement is required.
●
When you don’t use remote controller for a long time, please take out the
batteries.
●
If the display on remote controller is fuzzy or there’s no display, please
replace batteries.
NOTICE
5.
Press " " button to select fan blowing angle.
1.
Lift the cover along the direction of arrow (as shown in Fig 1
①
).
2.
Take out the original batteries (as shown in Fig 1
②
).
3.
Place two 7# (AAA 1.5V) dry batteries, and make sure the position of “+”
polar and “-” polar is correct (as shown in Fig 2
③
).
4.
Reinstall the cover (as shown in Fig 2
④
).
Fig.1
Fig.2
