bora PCH2, Инструкции по эксплуатации и монтажу

Страница: 18 / 28

EN
18
Installation
www.bora.com
1
L1 L2
2 3
N PE
220 - 240 V~
220 - 240 V~
Fig. 5.16 Connection diagram 2-phase
1
L1
2 3
N PE
220 - 240 V~
Fig. 5.17 Connection diagram 1-phase
X X
Create the connection between the cooktop and the
control box.
X X
Verify that the installation was done correctly.
X X
Switch on the main switch/automatic circuit breaker.
X X
Put the cooktop into operation
(see the Operation section).
X X
Check all the functions are working correctly.
5.7 Handover to user
Once installation is done:
X X
Explain the important functions to the user.
X X
Explain all safety-relevant aspects of operation and
handling to the user.
X X
Provide the user with the accessories and operating
and installation instructions to be kept in a safe place.
5.6 Power connection
X X
Observe all safety and warning information
(see the Safety chapter).
X X
Observe all national and regional laws and regulations
as well as the supplementary regulations of the local
utility companies.
INFO INFO The power connection may only be es-
tablished by a certified specialist. He/she also
assumes responsibility for the proper installa-
tion and commissioning.
The power supply line for use (pre-assembled) must be at
least Type H05VV-F or H05VVH2-F.
Q Q
Cross-section: 3G2.5 mm² with 1-phase connection
Q Q
Cross-section: 4G2.5 mm² with 2-phase connection
Q Q
If the connection line has been damaged this must be
replaced by a special connection line. This may only
be done by an authorized member of the After Sales
Service team.
Establishing the power connection
X X
Switch off the main switch/automatic circuit breaker
before connecting the cooktop.
X X
Protect the main switch/automatic circuit breaker
from being switched on without permission.
X X
Make sure the device is not energised.
X X
Only connect the cooktop using a permanent
connection to a power supply cable.