EN
21
Operation
www.bora.com
6 Operation
X
X
Observe all safety and warning information during
operation (see the Safety section).
INFO
The cooktop may only be operated when
the stainless steel grease filter of the cook-
top extractor is installed (see operating
instructions for cooktop extractor).
INFO
Clean the cooking zone before using the
cooktop for the first time (see the Cleaning
chapter).
6.1 Switching cooktop on/off
Fig. 6.1
Push and pull control knob
6.1.1 Switching on the cooking zone
X
X
Push and turn the control knob to power level
1
to
switch on the cooking zone.
Q
Q
The operating indicator light is active.
Adjusting the power level
X
X
Turn the control knob to the desired power level.
6.1.2 Switching on the power setting
INFO
Both cooking zones are equipped with a
power-enhancing power setting.
If a cooking zone is operated at power setting
P
, the other
cooking zones can be operated at a maximum power level
of
5
.
If the power setting is increased to
5
, the power level will
switch back to
P
.
X
X
Press and turn the control knob past power level
9
until the power setting
P
is shown on the cooking zone
indicator.
Q
Q
After 10 minutes, the cooking zone is automatically
switched back to power level
9
.
6.1.3 Switching the power setting off early
X
X
Turn the control knob past power level
9
again.
Q
Q
Power level
9
is active and is shown in the cooking
zone indicator.
or
X
X
Turn the control knob to the desired power level.
Q
Q
The power level set is active and is shown in the
cooking zone indicator.
6.1.4 Switching off the cooking zone
INFO
If a cooking zone indicator shows
H
, the
cooking zone is still hot.
INFO
Turn the cooking zone off after use. Do not rely
on the pan size recognition.
X
X
Turn the control knob to power level
0
to switch off the
cooking zone.
Q
Q
The operating indicator light is inactive.
Q
Q
The cooktop is switched off when there are no longer
any active cooking zones.
X
X
Pay attention to the residual heat display (see the
Device Description chapter).
6.1.5 Bridging function
Q
Q
If the bridging function is active, both cooking zones
will operate at the same time on the same cooking
zone.
Q
Q
If the bridging function is activated, the power setting
P
cannot be used.
Switching on the bridging function
X
X
Press and simultaneously turn both control knobs to
the left to the symbol
A
.
X
X
Release both control knobs.
X
X
Then turn the left control knob again to power level
9
.
X
X
Set the desired power level with the right control knob.
Q
Q
The bridge symbol
%
appears in the front cooking zone
indicator.
Q
Q
The selected power level (for both cooking zones)
appears in the rear cooking zone indicator.
Q
Q
The power levels of both cooking zones can now be
regulated at the same time with the right control knob.
Switching off the bridging function
X
X
Turn both control knobs to power level
0
; the bridging
function and the cooktop are switched off.
6.1.6 Automatic heat up function
Switching on the automatic heat up function
X
X
Press and turn the control knob for the desired cooking
zone to the left to the symbol
A
.
X
X
Within 5 seconds, select the desired power level
(continuous cooking stage), which should be used to
continue the cooking session after the end of the auto-
matic heat up function.
Q
Q
The cooking zone indicator will display the symbol
A
to
show that the automatic heat up function is activated
as well as the continuous cooking stage set, for
example
5
.
Содержание PC32
Страница 27: ......
