2. Warnings and Safety information continued
Medical warnings continued
DO NOT use if you have used any medicines or
products that have photosensitising properties
in the last 3 months. Appendix A on page 26
contains a list of common medicines and
products that may cause photosensitivity.
If you have a medical condition or you are
taking medicines and are unsure about
using the Boots Smooth Skin system,
seek medical advice before use.
Electrical warnings
The Boots Smooth Skin system is designed
for use in the UK and elsewhere in the world
where the mains supply voltage is 100V to
240V
AC 50/60 Hz. Use on other supply voltages
may
result in damage to the equipment.
After 50 shots in quick succession there is an
automatic cooling delay of about a minute where
the system will not respond—this is absolutely
normal and nothing to worry about. This cooling
delay is indicated by the ‘READY’ light flashing.
When it glows constantly the unit is ready to
use again.
After 200 shots within a 30 minute period there
will be a 5 minute automatic cooling delay where
the unit will not respond—this is absolutely
normal and nothing to worry about. This cooling
delay is indicated by the ‘READY’ light flashing.
When it glows constantly the unit is ready to
use again.
Check that the voltage rating marked on the
rating plate of the Boots Smooth Skin system
corresponds to the actual supply voltage.
Check that your Boots Smooth Skin system is
in good condition. Regular after use cleaning is
essential to maintaining the Boots Smooth Skin
system in optimum working condition.
DO NOT use if damage is found e.g. cracked
case, handset cable damage (internal wires
visible), cracked or badly chipped glass on the
handset etc. Internal parts contain energy levels
and voltages that are hazardous.
DO NOT use the Boots Smooth Skin system
in a bathroom or near sinks or other vessels
containing water. If the Boots Smooth Skin
system becomes wet it should not be used.
DO NOT coil the power cable around the power
supply during storage; this can lead to cable
damage and early failure.
DO NOT pull the handset cable tight, bend it
through very sharp angles or wrap it around the
unit for storage, this may cause cable damage
and early cable failure.
DO NOT use if either the base unit or hand unit
become hot to touch.
DO NOT dismantle; the Boots Smooth Skin
system contains no user-serviceable parts
and internal energy levels and voltages
are hazardous.
DO NOT use a power supply or any other
accessory unless they are specifically approved
and supplied for use with the Boots Smooth
Skin system. Use of accessories, which are not
approved, may be dangerous.
The Boots Smooth Skin system is designed to
operate between 15 – 30˚C.
ALWAYS unplug the Boots Smooth Skin system
when not in use.
8
Your Boots Smooth Skin system features a
SLEEP
mode
which
operates
after
approximately 1 hour in standby mode. When
this happens the STANDBY light on the unit will
flash approximately once per second. To return
the unit back into STANDBY mode, press and
hold any button until the STANDBY light
illuminates continuously, alternatively turn the
product off for a few seconds and then back on.
The unit will automatically go into STANDBY if
not used for approximately 1 minute, and the
green STANDBY light will come on. To use again
press the STANDBY button.
The Boots Smooth Skin system is now back in
STANDBY mode, to continue using the Boots
Smooth
Skin
system
press
the
STANDBY/READY mode button again.
Boots Smooth Skin User Guide.pdf 19/1/10 12:22:11
