Booster BMTV-9750DVUSBT, Инструкция по установке и эксплуатации

Страница: 7 / 54

BMTV-9750DVUSBT
- 6 -
WIRE CONNECTION
Cautions
1. To prevent short circuits, remove the key from the ignition and disconnect the
terminal of the battery.
2. Make the proper input and output cable connections for each unit.
3. Connect the wiring harness cables in the following order: ground wire, battery
wire, ignition wire.
4. Reconnect the terminal of the battery.
5. Do not connect the yellow wire of this product directly to the battery terminal.
6. Do remember to connect the red wire of this product to the ACC. of the ignition
key switch. Failure to do may result in draining off the battery charge prematurely.
7. If the fuse blows, first make sure that the cables have not caused a short circuit,
then replace the old fuse with new one with the same rating.
8. Do not let unconnected cables or terminals touch the metal on the car or other
conductor.
9. To prevent short circuits, do not remove the caps form unused terminals or from
the ends of the unconnected cables.
10. After the monitor unit is installed, check whether the brake lamps, blinkers, wiper,
etc. on the vehicle are working properly. If not, please make sure they are proper
installed.
11. Insulate unconnected wires with vinyl tape or other similar material.
Warnings
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-)
battery cable prior to installation.
Reconnecting the Battery
When wiring is complete, reconnect the battery negative terminal.
Fuse Replacement
Never replace any fuse with one of a higher value than the fuse supplied with
your unit. Using a higher current rated fuse may cause damage to your unit
and/or electrical wiring.