4
Limited Warranty
Boonton Electronics warrants its products to the original purchaser
to be free from defects in material and workmanship and to operate
within applicable specifications for a period of one year from date
of shipment for instruments, probes, power sensors and accessories.
Boonton Electronics further warrants that its instruments will per-
form within all current specifications under normal use and service
for one year from date of shipment. These warranties do not cover
active devices that have given normal service, sealed assemblies
which have been opened, or any item which has been repaired or
altered without Boonton’s authorization. Boonton’s warranties are
limited to either the repair or replacement, at Boonton’s option, of
any product found to be defective under the terms of these warran-
ties. There will be no charge for parts and labor during the war-
ranty period. The purchaser shall prepay inbound shipping charges
to Boonton or its designated service facility and shall return the
product in its original or an equivalent shipping container. Boonton
or its designated service facility shall pay shipping charges to return
the product to the Purchaser for domestic shipping addresses. For
addresses outside the United States, the Purchaser is responsible
for pre-paying all shipping charges, duties and taxes (both inbound
and outbound). THE FOREGOING WARRANTIES ARE IN LIEU OF ALL
OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT
LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FIT-
NESS FOR A PARTICULAR PURPOSE. Boonton will not be liable for any
incidental damages or for any consequential damages, as defined in
Section 2-715 of the Uniform Commercial Code, in connection with
products covered by the foregoing warranties.
Safety and Caution Summary
The following general safety precautions must be observed during all
phases of operation and maintenance of the Boonton 8201A Modu-
lation Analyzer. Failure to comply with these precautions or with
specific warnings in this guide or instruction manual violates safety
standards of design, manufacture, and intended use of the instru-
ments. Boonton Electronics Corporation assumes no liability for the
customer’s failure to comply with these requirements.
SAFETY
• INSTRUMENT MUST BE GROUNDED (must be connected to an elec-
trical ground at the power outlet)
• DO NOT OPERATE THE INSTRUMENT IN AN EXPLOSIVE ATMOSPHERE
• KEEP AWAY FROM LIVE CIRCUITS
• DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
• NON IONIZING RADIO FREQUENCY RADIATION HAZARD
• ELECTRIC SHOCK HAZARD
CAUTION
• Please check the power requirements as per the product specifica-
tions.
• Ensure at least 2 inches (5 cm) clearance around the instrument.
• Before powering the unit on make sure there are no indications of
exposure to extensive force such as dents, torn off pieces or loose
parts in the case.
• DO NOT touch connectors of components with bare fingers.
• DO NOT connect or disconnect any component of the test setup
with power switched on.
• To maintain the optimal performance of the unit, prevent exposure
to unnecessary force, keep accessories clean and dry, and regularly
check for wear and tear.
