HOW TO LOAD THE CAMERA INTO THE HOUSING
Open the housing back by releasing the latch, if it resists it's because the security lock is
in place - slide it upward to release.
Important
Be sure your arms, hands, head, and dive suit are ABSOLUTELY dry before opening the
housing. If possible, open the housing in an air-conditioned or otherwise dry cool room.
Have a dry towel handy. Keeping the inside dry is important to avoid condensation of
moisture on the lens during the dive.
Important
Any grit, sand particles or salt crystals gathered around the O-ring or corresponding edge
may cause leakage during your next dive. Dirt on the camera lens and the glass port of
the camera housing may appear as black spots on your pictures.
Important
The O-ring on the housing is made from a formulated silicone which requires no
lubrication; some
lubricants can damage the silicone and the seal
. Keep the silicone
and all sealing surfaces clean, as even a hair can cause leakage. Check the O-ring every
time you close the housing: if it is cut or worn, it should be replaced by an authorized
repair.
